Detailed · Deep study
1Resistance
Resistance opposes the current. For a given p.d., a larger resistance gives a smaller current.
Resistance is measured in ohms (Ω).
Worked example
Resistance
A current of 0.40 A flows through a resistor when the p.d. across it is 6.0 V. Find its resistance.
- 1
R = V ÷ I.
Answer15 Ω
Practical
Measuring resistance
Aim. To determine the resistance of a resistor (or a length of wire).
Method
- Set up the circuit with the ammeter in series and the voltmeter in parallel across the resistor.
- Adjust the variable resistor to obtain different currents; record V and I each time.
- Calculate R = V ÷ I for each pair and find the mean (or plot V against I: the gradient is R).
| independent variable | current (set by the variable resistor) |
|---|---|
| dependent variable | p.d. |
| controlled variable | temperature of the resistor |
Results. For an ordinary resistor at constant temperature R is the same for every pair of readings.
Safety. Switch off between readings so the wire does not heat up.
2Length and thickness of a wire
- A longer wire has a greater resistance – electrons have further to travel through the lattice.
- A wire with a larger cross-sectional area (thicker) has a smaller resistance – there are more paths for the electrons.
Worked example
Proportional reasoning
(Supplement) A wire 2.0 m long has a resistance of 6.0 Ω. What is the resistance of a 3.0 m wire of the same material with twice the cross-sectional area?
- 1
Length × 1.5.
- 2
Area × 2 halves R.
Answer4.5 Ω
3Current–voltage graphs (Supplement)
- Resistor (constant resistance): a straight line through the origin – current is proportional to p.d. (Ohm's law).
- Filament lamp: a curve that gets less steep – as the current increases, the filament gets hotter and its resistance increases.
- Diode: current flows in one direction only; in the reverse direction its resistance is very high and the current is (almost) zero.
4Exam focus
Key words: R = V/I; ohm; voltmeter in parallel, ammeter in series; longer → more resistance; thicker → less resistance; proportional to length; inversely proportional to area; filament heats up; diode one direction.
Quick self-check
Answer in your head first, then reveal.
3.0 ÷ 12 (1) = 0.25 A (1).
Longer – greater resistance (1); thicker – smaller resistance (1).
Curve / gradient decreases (1); filament gets hotter so resistance increases (1).
